Configure Interfaces
This section describes how to configure interfaces to be Individual interfaces compatible with clustering. Individual interfaces are normal routed interfaces, each with their own IP address taken from a pool of IP addresses. The Main cluster IP address is a fixed address for the cluster that always belongs to the current control node. All data interfaces must be Individual interfaces.
|
You cannot use subinterfaces. |
Procedure
| 1 |
Choose to add an IPv4 and/or IPv6 address pool. See Address Pools. Include at least as many addresses as there are units in the cluster. The Virtual IP address is not a part of this pool, but needs to be on the same network. You cannot determine the exact Local address assigned to each unit in advance. |
||
| 2 |
Choose , and click Edit ( |
||
| 3 |
Click Interfaces, and then click Edit ( |
||
| 4 |
On the IPv4, enter the IP Address and mask. This IP address is a fixed address for the cluster, and always belongs to the current control unit. |
||
| 5 |
From the IPv4 Address Pool drop-down list, choose the address pool you created.
|
||
| 6 |
On IPv6 > Basic, from the IPv6 Address Pool drop-down list, choose the address pool you created. |
||
| 7 |
Configure other interface settings as normal. |
||
| 8 |
Click Save. You can now go to and deploy the policy to assigned devices. The changes are not active until you deploy them. |
) next to the cluster.