Monitoring Routing
To monitor and troubleshoot routing, open Firewall Device Manager for the device and open the CLI console or log into the device CLI using SSH and use the following commands:
-
show routedisplays the routing table for the data interfaces, including routes for directly-connected networks. -
show ipv6 routedisplays the IPv6 routing table for the data interfaces, including routes for directly-connected networks. -
show networkdisplays the configuration for the virtual management interface, including the management gateway. Routing through the virtual interface is not handled by the data interface routing table, unless you specify data-interfaces as the management gateway. -
show network-static-routesdisplays static routes configured for the virtual management interface using theconfigure network static-routescommand. Normally, there will not be any static routes, as the management gateway suffices for management routing in most cases. These routes are not available to traffic on the data interfaces. This command is not available in the CLI console.